Tarjeta de desarrollo STM32, soporta Arduino, compatible con NUCLEO-F411RE.

Características:

• Compatible con NUCLEO-F411RE
• Microcontrolador Cortex-M4 STM32F411RET6
• Soporta shields Arduino
• Headers ST Morpho proven acceso total a todas las I/Os del STM32
• Soporta mbed
• Librería HAL incluyendo gran variedad de ejemplos
• Viene con un modulo separado ST-LINK/V2
• Compatible con Arduino UNO y Leonardo
• Interface Arduino ICSP
• Conectividad USB, con conector Micro USB
• Las interfaces comunes se conectan por medio de jumpers
• UART Debugging
• Cristal de 8MHz
• Cristal de 32.768KHz
• 4 LEDs
• Indicador UART
• Botón De posición
• ST-LINK separado
• 1 cable USB a micro USB
• 1 cable USB

Esquematico:

XNUCLEO-F411RE

1. STM32F411RET6
   
   • Core : ARM® 32-bit Cortex™-M4
   • Operating frequency : 100MHz
   • Operating voltage : 1.7V-3.6V
   • Package : LQFP64
   • Memories : 512kB Flash, 128kB SRAM
   • Interfaces : 1 x SDIO, 1 x USB 2.0 FS, 5 x SPI or 5 x I2S, 3 x USART, 3 x I2C
   • AD/DA : 1 x AD (12 bit, 16 channels)
2. SPX3819M5 : 3.3V voltage regulator
3. AMS1117-5.0 : 5.0V voltage regulator
4. CP2102 : USB to UART convertor
5. Arduino connector : for connecting Arduino shields
6. ICSP interface : Arduino ICSP
7. USB TO UART : for debugging
8. USB connector : USB communication interface
9. SWD interface : for programming and debugging
10. ST Morpho headers : access to VCC, GND and all the I/Os, easy for expansion
11. 6-12V DC input
12. User button
13. Reset button
14. Power indicator
15. User LED
16. 500mA fast self-recovery fuse
17. Serial port Rx/Tx indicator
18. 8MHz crystal
19. 32.768KHz crystal
20. ADC/I2C selection jumper
    
    • short A and B : Arduino A4, A5 is used as I2C
    • short B and C : Arduino A4, A5 is used as ADC
21. UART selection jumper
22. MCU current test jumper : for low power tests
23. Power selection jumper
    
    • short 5V and U5V : powered from USB connection
    • short 5V and E5V : powered from external power supply
24. USB enable jumper
    
    • short the jumper to enable
    • open the jumper to disable
25. User button jumper
    
    • short the jumper to connect to I/Os used in example code
    • open the jumper to connect to other custom pins via jumper wires
26. User LED jumper
    
    • short the jumper to connect to I/Os used in example code
    • open the jumper to connect to other custom pins via jumper wires

 Enlace al fabricante: